15641 Autoloader ALE: turtle W-axis not in position for plate hand-off Trendsetter_VLF Platesetter_VLF The Turtle W-axis was sent to the away position but the home/away board does not detect the away tab. The nvs parameter "step 6 away_limit" may be too small so that the turtle W-axis does not reach its destination. The turtle home/away board may not be working properly. The picker is preventing the turtle W-axis from reach its away limit. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:17 2008 PST http://techplanet.creo.com/output/computer_to_plate/vlf_platesetter/content/troubleshooting/15641.htmOther: Troubleshooting information